With the rapid development of industry, companies are pursuing higher work efficiency. The dehumidification dryer integrates dehumidification, drying, and feeding. It has the advantages of simple operation, fast feeding, and high drying efficiency to meet the production requirements of the enterprise, and gradually replace the traditional hot air dryer. Dehumidifying dryers are mainly used to dry highly hygroscopic plastics. The dehumidified low dew point air is sent to one or more standard drying hoppers to improve drying efficiency and shorten drying time. So what are the operating steps of the plastic resin dryer? Now a professional technician from Hengrong will explain to you:
Operation steps of plastic resin dryer:
1. Make sure that the plastic resin dryer has been installed and adjusted;
2. Turn on the power switch on the control box power supply and the dehumidifier panel;
3. Check the temperature indication of the material barrel frequently, and repair it in time if any malfunction is found;
4. When the temperature rises to the specified temperature, check whether it is consistent with the temperature of the lower part;
5. Keep the barrel full at any time during production;
6. The raw materials can be produced only after the specified drying time is fully reached;
7. When the drying is completed, when the machine is to be shut down, close the feeding plate first, and then close the feeding system after pumping the bottom raw materials.
8. Turn off all the run buttons on the operation interface and turn off the main power supply.
The operation steps of the desiccant dryer are introduced here today. In addition, the editor reminds that when the desiccant dryer is running, be careful not to touch the body to avoid being burned. In order to extend the life of the equipment, regular maintenance is also required.
|
+8613669807274
+8613669807274
wto-btb@wto-btb.com
Tel: +8613669807274
SMS: +8613669807274