The desiccant dryer should be cleaned and kept clean from time to time. The dehumidifier should be placed in the center of the room. The air inlet and outlet of the refrigerated dryer should not be blocked by obstructions, and the air filter should be clean. When the ambient temperature exceeds 15°C, the water droplets covering the surface of the evaporator will freeze and the effect of the dehumidifier will be weakened. If the ambient temperature exceeds 40°C, the pressure in the system will increase and the compressor will expand. Cut off the line, otherwise the compressor motor will be damaged. Therefore, the best operating temperature range of the dehumidifier is 15°C~40°C. If the humidity in the air is below 30%, it is too dry and uncomfortable. Therefore, a reliable humidity controller takes control to maintain the range of 50% to 60%. When in use, the doors and windows are adjusted and closed, so that the indoor dehumidification effect can be achieved. The body of the desiccant dryer must be placed, not tilted or down, to avoid machine failure or abnormal noise.
The water storage in the desiccant dryer is too full. In order to avoid overlapping and contaminating the ground, when the machine body must be moved during operation, please unplug the power cord first, and then pour out the water in the water storage bucket. Swing for four to six hours before turning it on again, because the compressor pipeline in the dehumidifier contains cold coal. After being moved, the cold coal must return to its original position after four to six hours. Once) to maintain the dehumidification, dust removal efficiency and life of the machine. Clean the air filter and wash it with water below 40℃; it is better to clean it with detergent. After washing off the dust, rinse it with water, dry it in the shade and put it back into the body. Clean the surface of the body with adhesives. Use soapy water to clean it. Avoid spraying it with gasoline, petroleum spirit, solvents or spray insecticides. Use thin rods or iron wires to dig out the inside of the machine to avoid malfunction or danger. If there is a power outage or long-term use, when traveling, replace the power cord and unplug it to maintain the life of the machine.
|